 | | Re: Strong gear assemble? —Jason Stern
|
| | | Im ahead of you there, I already did that :p. I need to add even more torque. The the current setup is this: worm to central 40pt gear, 40pt's axle is connected to one 8pt gear on either end and then after that a 16 (i think)on each end also. The (...) (24 years ago, 22-Sep-00, to lugnet.robotics)
|
| | | |
| | | | | Re: Strong gear assemble? —Tilman Sporkert
|
| | | | | (...) 1:40. There's a single thread on the worm, moving one "tooth" per revolution. That gives you the same ration as 1 tooth gear. As has been discussed before, the characteristics of this worm gear reduction will be slightly different than (...) (24 years ago, 22-Sep-00, to lugnet.robotics)
|
| | | | | |
| | | | | Re: Strong gear assemble? —Adam
|
| | | | (...) 1:40 - The worm gear is *effectively* a 1-tooth gear. -Adam (24 years ago, 22-Sep-00, to lugnet.robotics)
|
| | | | |
