Subject:
|
Re: Expanding the available input/output ports of the RCX
|
Newsgroups:
|
lugnet.robotics, lugnet.robotics.rcx
|
Date:
|
Mon, 10 Jul 2000 01:16:05 GMT
|
Viewed:
|
1397 times
|
| |
|
|
Ram Meenakshisundaram schreef:
>
> Hi,
>
> With only 3 input and 3 output ports, the RCX becomes quite limiting after a
> while. There are several different solutions to this at various sites.
> Does anyone know which one is the best out of all of them. I basically
> looking for good functionality and ease of use. Thanks....
You could use the sensors that came with the Cybermaster kit, they have a
built-in resistor so it should be possible to hook up two of those on one
input port and by using RAW values see which switch is pressed.
--
Jan-Albert "Anvil" van Ree | http://www.nl.3dgamers.com
3D Sims Archive maintainer | http://www.3dgamers.com
Thrustmaster Resource Center | http://www.3dgamers.com/tmresourcecenter/
|
|
Message is in Reply To:
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
