Subject:
|
Re: reading sensor values?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 28 Mar 2000 05:45:27 GMT
|
Viewed:
|
1719 times
|
| |
|
|
The values displayed on the LCD using Robolab 1.x were not the "raw" values. In
Robolab 2 all the sensor adapter icons (pH, sound, etc.) set the sensor mode to
"raw" mode. There is a generic sensor under the sensor adapter icons that uses
the raw mode too. Do you want to use raw mode to increase the granularity of
your sensors?
Try out Robolab 2.0, it is a very powerful programming platform for the RCX. In
particular the Investigator options are unbeatable.
In lugnet.robotics, Randall Thomas <rthomas@ptd.net> writes:
> > Now pass something under the light sensor, and
> > you will see the value it returns on the LCD screen of the RCX. You can
> > also set the values the sensor returns to raw.
>
> Simon,
> Is the ability to set the values the sensor returns to "raw" only available
> in NQC. We're using Robolab 1.5 here, soon 2.0. I was under the impression
> that the values displayed on the RCX LCD were the "raw" values.
> Randall
|
|
Message is in Reply To:
 | | Re: reading sensor values?
|
| (...) Simon, Is the ability to set the values the sensor returns to "raw" only available in NQC. We're using Robolab 1.5 here, soon 2.0. I was under the impression that the values displayed on the RCX LCD were the "raw" values. Randall (25 years ago, 25-Mar-00, to lugnet.robotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
