To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *9971 (+5)
  RcxCC for NQC 1.1?
 
I just downloaded RcxCC and noticed that it is still using NQC 1.0b4 Was the RcxCC project abandoned? Why it still uses an outdated version of NQC? Are there any other good alternatives to RcxCC for the new NQC? Thanks Laurentino Martins (...) (28 years ago, 7-Mar-99, to lugnet.robotics.rcx.nqc)
 
  stepper motors
 
Hi : I am looking for a stepper motor that works at 7V. I was wondering if any of you have used stepper motors for the handyboard or the Rug Warrior. If so, what model did you use and what was your selection criterion for the motors. Thanks. (28 years ago, 7-Mar-99, to lugnet.robotics.handyboard)
 
  Re: sale at eToys
 
Dear Arsehole (AKA Brian) Thank you very very very much for the binary posting of several large zip files. I was completely uninterested in receiving some nonsense about PalmPilots (perhaps this an appropiate item for a five-knuckle-shuffler such as (...) (28 years ago, 7-Mar-99, to lugnet.robotics)
 
  Re: More Output ports!
 
I would be interested in seeing what you have done. How do you control the switch, with the third RCX output ? -- SeeYa ! ---...--- Jim ---...--- Hello... Is this thing on ? John Brubaker wrote in message <36e2aace.12707929@l...et.com>... (...) (28 years ago, 7-Mar-99, to lugnet.robotics)
 
  Re: Sharp GP2D02 code available
 
Hi Barry, I have a GP2D05 from Acroname Inc., Have wired as per instructions black for gnd., green for Vin, Yellow for Vout, and red for Vcc.The pin outs are different than the GP2D02. Then installed the diode and connectors for the handyboard .as (...) (28 years ago, 8-Mar-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR