 | | Re: Motor power?
|
|
I have a tracked bot and I can notice the difference in speed when I set the motors to 1 or 4 or 8. John A. Donaldson (...) (28 years ago, 16-Feb-99, to lugnet.robotics)
|
| |
 | | Re: RCX IR Messages & Universal Remotes
|
|
Ben, I've been trying to use my Palm III with OmniRemote to send messages to the RCX but so far with out success. What was the process you used to train your buttons? What I am doing is using nqc to send a message through the IR tower which I try (...) (28 years ago, 5-Feb-99, to lugnet.robotics)
|
| |
 | | Easy communication between HBs
|
|
After struggling with it for many hours I found an alternative to Randy's serialio.c serial communication which I couldn't get working. So I used the Pa7_9600 Baud Serial output from unknown origin (Fred?) ((URL) ial.html). I cut a standard RJ11 (...) (28 years ago, 17-Feb-99, to lugnet.robotics.handyboard)
|
| |
 | | A-S -> Adaptive Transmission (long)
|
|
My own incarnation of the much discussed A-S transmission uses a single differential and relies upon software to synchronize two independent drives. I term my gearing and software system an Adaptive Drive, since it continuously monitors differential (...) (28 years ago, 17-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Sonar and RF Modem questions
|
|
I've been looking into this also. I purchased the Parallax RF module, which is very simple to use. However, it seems to provide a transparent RS232 interface, more is needed than this, or at least some data buffering. Linx technologies provides a (...) (28 years ago, 17-Feb-99, to lugnet.robotics.handyboard)
|