 | | senor signal line back to HD
|
|
Hi, Currently, I'm using a infra-sensor with supply by 12v external source battery.The signal line wire is plug directly into the HD digital or analog port. The positive and negative supply of this infra-sensor is connected to the external supply (...) (28 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | 6.270 vs. Handy Board motor stuff
|
|
[Max Davis] spake unto the ether: (...) Too much current (and voltage) for those original Polaroid motors, which are 6-volt. (...) I heat-sink mine with the clip-on variety; it helps. (...) I have done the 6.270 piggyback hack with the motor driver (...) (28 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Out of TIC Inputs
|
|
Hi everyone. I'm running the HB 1.2 with the expansion board. I've installed the 6500 ranging system and use servo ports 1 through 3. I now have two wheel encoders functioning and desire to use the IC encoder routines. My problem is that I've got (...) (28 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Un-Subscribe
|
|
Un-Subscribe -- Did you check the web site first?: (URL) (28 years ago, 22-Jan-99, to lugnet.robotics)
|
| |
 | | CFD: robotics sub-groups
|
|
Last week, the topic came up about creating a special new group for Robot Arena. (See (URL) for more details and how the thread unfolded.) Assuming this belongs inside the .robotics hierarchy (rather than inside a separate .events hierarchy), a (...) (28 years ago, 22-Jan-99, to lugnet.admin.general, lugnet.robotics)
|