To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *7981 (+5)
  RE: gpu5x??
 
Step 8.2.1 of the Handy board Assembly insructions has code that lights a motor port LED when a TV remote is aimed at the infared demodulator it says to type the following at the IC prompt: while (1) {if (4 & peek(0x1000)) fd(0); else bk(0);} (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
 
  help again
 
thanks to the immediate responses from the mailing list I was able to remove the connector bug from my handy bosrd and now my interface board is complete. But the handy board does not enter the download mode The sitution is as follows: Once I (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
 
  Continuous charging
 
Graham, J. Todd wrote: <snip> (...) If you use zap charge mode, you'll end up cooking your batteries unless the HB draws just the right amount of current. If you use any motors or other high current devices connected to the HB, trickle charge mode (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
 
  Grounding robots
 
(...) By ground, I just meant the HB ground. The important thing is just that everything in an electronic system share the same ground; voltages are relative, and the ground is just the shared reference point--the point arbitrarily defined to be (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)
 
  Re: help again
 
check that the RxD line on the hc11 is properly pulled up to +5v through R15. also, make sure you are *HOLDING DOWN* the STOP button until the BATT light goes off. this wasn't clear from your msg. finally, try getting the HB into boot mode with the (...) (28 years ago, 16-Jan-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR