To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6921 (+5)
  Re: sensor input mux calculations
 
Sinse it has been real quite at work, I did some designing and came up with what I think would be a solution. Using Sensor ports A & B, these could be tied to sense the channel select lines of a Analog Multiplexer. The C port would be connected to (...) (28 years ago, 30-Dec-98, to lugnet.robotics)
 
  99 Catalog scans complete
 
well, all done scanning them, where to put them? there is a total of 2.61 MB of them, all the new ones up to the Search and Rescue Complex (P 29), will scan the rest tommorw, I ran outta space on my C: drive, where the scanner software holds a temp (...) (28 years ago, 30-Dec-98, to lugnet.general, lugnet.robotics)
 
  Squeezing 4 inputs out of 1
 
I've constructed a circuit that will read four switches from one input port. Theory- The input port is an A/D circuit. It reads voltage as opposed to state. The A/D line is wired to a 10K ohm resistor that is in turn wired 5 volts. Thus if it is (...) (28 years ago, 30-Dec-98, to lugnet.robotics)
 
  Squeezing 4 inputs out of 1
 
I've constructed a circuit that will read four switches from one input port. Theory- The input port is an A/D circuit. It reads voltage as opposed to state. The A/D line is wired to a 10K ohm resistor that is in turn wired 5 volts. Thus if it is (...) (28 years ago, 30-Dec-98, to lugnet.robotics)
 
  RE: sensor input mux calculations
 
This design would prevent multiple switch detection. Only one switch would be detectable (the last one). The designs people have been creating so far have been capable of detecting 3-4 discrete inputs at any time regardless of the settings of any (...) (28 years ago, 30-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR