To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6901 (-10)
  Re: (long) Rotation Sensor from "Extreme Creatures" Fiber Optics
 
(...) Here are some ideas Maurice Hilarius sent me on the subject. I hope he doesn't mind my reposting them. "1) You attach a smaller wheel on a shaft which is part of the drivetrain. This wheel rotates on the shaft, but with a small amount of (...) (28 years ago, 29-Dec-98, to lugnet.robotics)
 
  RE: digital inputs?
 
hi everyone, i would like to know if there is any digital inputs other than the 16 inputs used for the sensors. which means i would like to have more inputs! is this possible? from michael (28 years ago, 29-Dec-98, to lugnet.robotics.handyboard)
 
  encoder to handyboard?
 
dear readers and fred martin my DC motor comes with a 10 pin optical encoder(supply current-10mA) how do i connect my encoder part to the handy board? can i ignore the encoder? my robot only needs to sense retroreflective white tape, can i just use (...) (28 years ago, 29-Dec-98, to lugnet.robotics.handyboard)
 
  Re: (long) Rotation Sensor from "Extreme Creatures" Fiber Optics
 
-I though it was pretty weird reading this elaborate setup to do rotation sensing with a light sensor and a light gizmo. -Its funny that they never really said anything about it in the manual. Is there info on the cd? -Now, if i could just tell (...) (28 years ago, 29-Dec-98, to lugnet.robotics)
 
  Photocells?
 
I am seeking help in locating suppliers of quality photocells or light sensing equipment suitable for use in a handyboard environment. Thanks! (28 years ago, 29-Dec-98, to lugnet.robotics.handyboard)
 
  Re: More input
 
Check the URL Mike, I hit a dead end. (...) -- Richard Clemens, Associate Professor Computer Science Department West Virginia Wesleyan College 59 College Avenue, Buckhannon, WV 26201 304-473-8421 clemens@wvwc.edu -- Did you check the web site (...) (28 years ago, 29-Dec-98, to lugnet.robotics)
 
  Re: (no subject)
 
No. The 10k resistor that pulls up the input line and a resister that is put across the connection form a voltage divider. The formula given calculates the fraction of the voltage that will be at the junction of the two resisters. That voltage is (...) (28 years ago, 29-Dec-98, to lugnet.robotics)
 
  Re: (long) Rotation Sensor from "Extreme Creatures" Fiber Optics
 
Great!!!...!!! It works. Now I have two angle sensors (8456 & 8480) :-)))...))) BTW, this is how it works: The led inside is *ON* only when it is under one of the eight holes. It has a (presumably 10K, since I read 523 in raw mode) current-limiting (...) (28 years ago, 29-Dec-98, to lugnet.robotics)
 
  Re: More input
 
A similar scheme can be found at: (URL) Just go to the section about dealing with only three inputs. Mike G. (28 years ago, 29-Dec-98, to lugnet.robotics)
 
  Re: CdS Light Sensor
 
Mouser catalog is online at: www.mouser.com it has data sheets for many of their parts in .pdf format. Mike G. Fred Carcanague III wrote in message ... (...) (28 years ago, 29-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR