 | | legOS-0.1.3
|
|
Hello, legOS now supports active light sensors. Newest version at: (URL) is an unofficial native mode kernel for the Lego Mindstorms RCX. It features preemptive multitasking, energy saving, dynamic memory management, POSIX semaphores, native access (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | How to get digital outputs from the handyboard???...???
|
|
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Pre-LEGO British bricks
|
|
Eric Brok wrote in message ... (...) To answer my own questions: Kiddicraft (URL) Brok (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | Re: Wall Street Journal on Lego Mindstorms
|
|
(URL) has this article for subscribers. I found it by searching for Mindstorms. It doesn't give back a URL useful for anyone else, but others can probably the article by doing the same search. alex (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | Pre-LEG British bricks
|
|
What again was the name of the British bricks back when LEGO started? What again was the webpage with pictures of them? Eric Brok (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | Re: 2 RCX communication on the same model
|
|
(...) You mean the RIS/GUI language? It _does_ have an IR message function. (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | Servos for the miniboard
|
|
I would like to use a servo to operate the throttle of a small gas engine. I am planning on using the miniboard to control the servo. Are there any brands to avoid? Are there any brands that are far better than the rest? Will just about any RC servo (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | How to get digital outputs from the handyboard???...???
|
|
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Out of range
|
|
Hi, I have some code that does this but it get kind of complicated to explain but here goes.... 1. I have a separate thread in my (C++) app that is used to poll the cybermaster variables. I can set which variables to check under program control. 2. (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
|
| |
 | | How to get digital outputs from the handyboard???...???
|
|
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|