To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6216 (-10)
  Re: 2 RCX communication on the same model
 
(...) You mean the RIS/GUI language? It _does_ have an IR message function. (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  Servos for the miniboard
 
I would like to use a servo to operate the throttle of a small gas engine. I am planning on using the miniboard to control the servo. Are there any brands to avoid? Are there any brands that are far better than the rest? Will just about any RC servo (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  How to get digital outputs from the handyboard???...???
 
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  Re: Out of range
 
Hi, I have some code that does this but it get kind of complicated to explain but here goes.... 1. I have a separate thread in my (C++) app that is used to poll the cybermaster variables. I can set which variables to check under program control. 2. (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  How to get digital outputs from the handyboard???...???
 
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  Re: Stepper vs DC
 
It depends. if you are looking for higher top speed and more torque using less power, DC may be the way to go. If you want accuracy but don't want to deal with shaft encoders and the code overhead needed to precisely control and monitor your DC (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  Wall Street Journal on Lego Mindstorms
 
The Wall Street Journal has a nice (albeit technologically simplified) article today on Lego Mindstorms' popularity among adults. It's not, to my knowledge available on-line, and for copyright reasons I won't post it all here. But here's a couple (...) (28 years ago, 10-Dec-98, to lugnet.announce, lugnet.general, lugnet.robotics)
 
  Out of range
 
[transferred to a new thread] I'm trying to create a good algorithm for detecting out of range situations with the tower, using NQCC. Have anybody already found a good way of doing this? My guess is that this is not possible, but... I have a (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  Re: Where to buy in London
 
In article <VA.000017c1.05e516c...pthought>, John Cooper <robots@jpsc.co.uk> writes (...) ... and the shop at Legoland Windsor is open until sometime before Christmas. I got mine (well my sons!) the for a 10% discount off UKP160 as he was a lego (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  Re: Communicating with IR tower
 
(...) Have you already done this? (detect out of range situations?) I'd really would like to know how did you do it! I also have a CyberMaster and I'm working with NQCC and with the Spirit.OCX in VC++. Thanks! Laurentino Martins (...) (28 years ago, 10-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR