To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6186 (+5)
  Re: Delphi developers
 
John: I haven't heard about Delphi, but some have created other ways to program the RCX. See my Mindstorms page and look under the Alternate Programming Environments section. The page is located at (URL) Nelson nelsonb@vii.com (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  Re: DC Motor movement
 
(...) Each motor may have slightly different characteristics even though they may be the same brand and model. This is what you are probably seeing. The ultimate solution is to use a feedback mechanism, like a shaft encoder, on the motors and use (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  Re: RCX Command Center
 
Found the problem. I normally run code like this from the D: drive. It seems that unless I have the NQC dir on the C: then it can not find "Command.com". Once I moved the NQC to the C: and remapped my icon, then it alled worked. Would it be (...) (28 years ago, 9-Dec-98, to lugnet.robotics)
 
  unsuscribe
 
unsuscribe (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  ...-help@...
 
(28 years ago, 10-Dec-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR