 | | HB Mail List
|
|
Please add me to the Handy Board mailing list. Thanks, Bill william.carlquist@tek.com (29 years ago, 8-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | code
|
|
I'm struggling to program my bot. In an effort to make my life slightly easier for myself, I'm searching for any bot code that anyone would like to offer me. I'm especially interested in routines that involve navigation, mapping, shaft (...) (29 years ago, 9-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | RE: code
|
|
---...--- From: Jeff Keyzer[SMTP:jkeyzer@calweb.com] Sent: Monday, July 08, 1996 7:30 PM To: Handy Board Subject: code I'm struggling to program my bot. In an effort to make my life slightly easier for myself, I'm searching for any bot code that (...) (29 years ago, 9-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Re: RE: code
|
|
(...) Me Three! (29 years ago, 9-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | re: RE: code
|
|
Me Too ! Jens (29 years ago, 9-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Questions, questions, questions......
|
|
Hi I've just built my first HandyBoard (thanks for the great service Prabal), and have a few questions (that I can't find in the FAQ). What are the hardware-imposed software differences between the HandyBoard and the 6.270/Rug Warrior boards ? ie it (...) (29 years ago, 10-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Questions, questions, questions......
|
|
(...) The Handy is like the 6.270; both have dig out latches going to the motors. The RW drives the motor ctrl pins directly. A re-write of the system PWM routines could provide finer than 8 levels of control, even w/o needing HW timer lines. (...) (...) (29 years ago, 10-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Cursor Position
|
|
Hi, I was wondering if there is a way to position the cursor directly. Using IC's printf function works great, but I can't position the cursor exactly where I want it. I'm trying to display a dynamic bar graph and some other information based on the (...) (29 years ago, 10-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | L293 vs TI 754410
|
|
HI Just wondering what kind of success anyone has had with piggy-backing the L293's. My HB came with the TI h-bridge chips and I wanted to know if I could use the same technique. I figure if two chips can be run in parallel, giving up to 2A for each (...) (29 years ago, 10-Jul-96, to lugnet.robotics.handyboard)
|
| |
| | Source for LCD's
|
|
FYI all electronics ((URL) has 3 LCD displays that could be used with the handy board: Optrex DMC-16207 16 char * 2 lines Hitachi LM052L 16 char * 2 lines Sanyo LCM-524-87H4 40 char * 2 lines Price is 12$ each, any model. Can someone confirm (or (...) (29 years ago, 10-Jul-96, to lugnet.robotics.handyboard)
|
