|
|
 | | Re: your mail
|
| (...) Very confusing, especially since at the beginning of the same file, there are the lines: * Setup Interrupt for Encoders * LDX #BASE BSET TCTL2,X %00001100 /* Interrupts TIC3,TIC2 rising edge*/ BCLR TFLG1,X %00000010 /* Clear IC3,IC2 Flags */ (...) (29 years ago, 28-Jun-96, to lugnet.robotics.handyboard)
| | | | | Re:
|
| (...) Lyle, The following provide PLCC-to-breadboard adapters: Amaze Electronics Co. Tel: 1-800-996-2008 Web: www.hooked.net/users/amaze Technological Arts Tel: 1-416-963-8996 Web: www.io.org/~techart You can see their ad on the July 1996 issue of (...) (29 years ago, 29-Jun-96, to lugnet.robotics.handyboard)
| | | | | (no subject)
|
| In regards to the bit manipulations of the timer flags... I concede. At this time I have neither the mental capacity nor the desire to figure out what is correct. After copying the paragraphs earlier, I am only sure that the documents could use some (...) (29 years ago, 29-Jun-96, to lugnet.robotics.handyboard)
| | | | | timer flags
|
| The timer flags are cleared by either loading the accumulator with the bits you want cleared and then storing them in the timer flag register, or by using BCLR with a complemented mask. -Dirk "I speak from experience" (29 years ago, 29-Jun-96, to lugnet.robotics.handyboard)
| | | | | cher is shut down until further notice
|
| until i figure out how to disable the incoming directory from crackers. -Fred (29 years ago, 1-Jul-96, to lugnet.robotics.handyboard)
|
|
