To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5451 (+5)
  Re: One tip, and a few questions.
 
In article <01BE14B1.B5C66E80.e...inum.com>, Eric Hodges <eric.hodges@platinum.com> writes (...) In the fifties I built a heat-seeking swivelling "eye" using that method with valve (tube) technology. The IR detector was an old fashioned glass (...) (28 years ago, 21-Nov-98, to lugnet.robotics)
 
  4x4 'bots (was Re: Misc. Lego parts)
 
Wow! I thought I was the only nut working on such a 'bot. 4x4 models are my fetish. Over the last couple of years I've built several with just Technic parts. I've been hacking for two weeks on a non-sprung steering system with drive shafts. Today I (...) (28 years ago, 21-Nov-98, to lugnet.robotics)
 
  Re: motor port problem
 
(...) to make the connector more physically and electrically stable. (...) of course, only 2 connections are needed to make a ckt. (...) you should figure up to several amps of current flow. (...) it should work fine. good luck. fred (...) (28 years ago, 21-Nov-98, to lugnet.robotics.handyboard)
 
  Using 30VDC to drive motors
 
Hello, I have finished building Matt Harlan's H-Bridge circuit (from the Handyboard FAQ) and I have come across the following instructions: "Make sure the supply ground for the 18200's is connected to the HB ground. You'll get some very strange (...) (28 years ago, 21-Nov-98, to lugnet.robotics.handyboard)
 
  MAP Bot
 
I have a idea which is based on a project I worked on back in the 70's. It used one of the sonar devices that Poliord used to foucse their camera with. This device is availible without the camera. It sends a signal based on how far the object is. (...) (28 years ago, 21-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR