To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5426 (+5)
  Re: Building gcc
 
Hello, Some time ago I tried to compile binutils 2.9.1 for H8/300 with cygwin on NT and I was also getting compilation errors. People from the binutils development team (Ian Lance Taylor, ian@cygnus.com and Kai Ruottu, karuottu@freenet.hut.fi) (...) (28 years ago, 20-Nov-98, to lugnet.robotics)
 
  Re: One tip, and a few questions.
 
(...) 0-100. 100 being very very bright. (28 years ago, 20-Nov-98, to lugnet.robotics)
 
  Re: Sharp IS1U60 availablity
 
Check B. G. Micro 800-276-2206 www.bgmicro.com I would not be too concerned with the actual part number, just look for an Infared sensor or remote control sensor. Also get the pin outs as these may be different. Also have you considered using fewer (...) (28 years ago, 20-Nov-98, to lugnet.robotics.handyboard)
 
  Re: motor port problem .
 
Philip In a message dated 98-11-19 21:05:04 EST, you write: << hi, I have a big problem. I followed the method of yours that just lift up pin 8 of one L293 and wirewrapped it. The positive supply is wirewrapped to pin 8 . How about the negative (...) (28 years ago, 20-Nov-98, to lugnet.robotics.handyboard)
 
  TEST
 
TEST (28 years ago, 20-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR