 | | MindStorms on NT / trouble posting to the list
|
|
I'm posting this question on behalf of peterbag@microsoft.com. Please direct replies to that address... Peter asks, Help! I am considering purchasing a MindStorms kit tonight, but I want to make sure it will run under WindowsNT. Has anyone done (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
Alex Wetmore wrote in message <008601be0f2a$01b821...ft.com>... (...) This would give you a good turning radius. However, it would take the bot a long time to turn. (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
Ardjan Besse wrote in message <364c7d42.4532817@lu...et.com>... (...) "Straight" is a relative term. For example, while the alignment might be 0straight, the wheels might not provide the bot with the ability to travel in a straight line. I believe (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
(...) 1) You've been playing too much Carmageddon. 2) Control theory is relatively new (it paces the development of computers). There are quite a few good textbooks available, but a professor is a much greater help. Familiarity with calculus and (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
Daniel Miller wrote in message ... (...) What? (...) This is all fine and well, but I was thinking about something a little less complex. The RCX doesn't have the power to perform image processing and sophisticated feedback control. What I was (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re:
|
|
Hi everyone, The mistake you make in your calculation is that in your calculation you take the entire 15V for the resistor and this leaves no voltage for charging your NiCad. Do the same thing again and deduct your NiCad voltage from the 15V you (...) (28 years ago, 14-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | Cybermaster protocol?
|
|
Does anybody have information on the basic Cybermaster packet protocol handy? How does it differ from the 55 ff 00 D ~D D ~D C ~C format of the RCX? -Kekoa (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
(...) Believe it or not, I've been working on exactly this problem for the last few days. I built an angle sensor using a 500K potentiometer wired directly to an RCX input port. (Lego's angle sensor doesn't have sufficient angular resolution unless (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Homebrew sensors?
|
|
(...) So's Michael - he's proposing a notch filter so you get the amplitude at a particular frequency, which may be better for a seeking application. Cheers, Ben. (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
(...) I think making the pendulum longer should cure this... (...) Possibly making it heavier will cure this... Cheers, Ben. (28 years ago, 14-Nov-98, to lugnet.robotics)
|