To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5231 (-5)
  Re: how to adapt a voltage signal?
 
You could use resistors to make a 1/10 voltage divider. If you need high input impeadance, you could build an Op-Amp circuit to divide the voltage by 10. Most ADC chips have a pin that is the reference voltage for the high end of the scale--set this (...) (28 years ago, 13-Nov-98, to lugnet.robotics.handyboard)
 
  Re: moving in a straight line with two motors?
 
(...) This all depends. The table you gave (presumably from the date sheet), said: (...) Now, Lego uses Off to mean Brake and Float to Off ... (...) Well, you can set the motor to "float" and you do coast. (...) Please explain why there is (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  Re: moving in a straight line with two motors?
 
(...) kp> There needs to be a link to this somewhere: kp> Peter Phillips pointed out a long while back (my messages from him are kp> dated Sep 21) that the specs to the chip are here: (...) kp> drivers. OK, 500mA per driver. Which, if the rest of my (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  Homebrew sensors?
 
I've been brainstorming for a while about what could be done with a kludge. I'm more into the whoosh-bang side of engineering than the beep-zap, so I don't know if it would work... A few years ago, Estes (the model rocket people) made a "rocket (...) (28 years ago, 13-Nov-98, to lugnet.robotics)
 
  Re: moving in a straight line with two motors?
 
I believe you are thinking of Leo Dorst's adder/subtractor. I had been eyeing this myself for use with mindstorms, since it would seem to solve the "differing motor RPM phenomena" problem. (...) (28 years ago, 13-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR