 | | Re: Multiplexing Input Circuit
|
|
(...) The counter is a CMOS decade counter that has only one output high for each count. There is only one analog switch on at a time. The counter is reset when it hits the value 5 so it jumps back to 0 to start over. The analog switch is (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Connecting two HandyBoards through their serial ports
|
|
Gads Bill, you are right and my info in the FAQ is dead wrong. I have updated the FAQ with the corrected information. *Thanks a lot* for working this one through. There are few things more annoying than completely wrong documentation (compiler bugs (...) (28 years ago, 12-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Multiplexing Input Circuit
|
|
(...) Looks good! How about using the third input port to assert the reset line and set the counter back to zero? Is your counter set up as a binary counter? From your diagram it looks like there are times that more than one sensor would be active (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Multiplexing Input Circuit
|
|
(...) Require it to be clocked every so often, reset if it is held high for a certain length of time. Alternatively, it may be possible to drop the voltage to zero - but that would require a firware change... anyway, I'll look into it out of (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Connecting two HandyBoards through their serial ports
|
|
Hello, everyone: Richard Drushel helped me solve the problem that I was having in getting two HandyBoards to communicate through their serial ports by suggesting that I check to be sure that the wiring on the RJ11 cable I was using corresponded to a (...) (28 years ago, 12-Nov-98, to lugnet.robotics.handyboard)
|