 | | HB Pcode v3.2 Source... (Was: Motor output)
|
|
-----Original Message----- From: Eric Noyau <noyau@apple.com> To: William Bain <willbain@cs.umt.edu> Cc: handyboard@media.mit.edu <handyboard@media.mit.edu> Date: Thursday, October 29, 1998 8:39 PM Subject: Re: Motor output (...) <snip> (...) not (...) (28 years ago, 30-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: DC motor voltage source
|
|
phillip: Pine 8 for the L293D is "Motor Power." There are two ways to get to this. 1) Pull the chip from the socket, lift the pin so it points straight up, then wire-wrap a new supply wire to this pin. Or scratch the trace leading to pin 8 U11 and (...) (28 years ago, 30-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Sonar Sensor Problems
|
|
(...) The dual sonar interface board is simply a small (1.5" sq. or so) experimenter's PC board from Ripoff Shack with the six power diodes, the one resistor, and three header plugs soldered onto it. One plug goes to the HB and the other two go to (...) (28 years ago, 30-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Sonar Sensor Problems
|
|
Thanks for doing all this testing and reporting it to us. I do really appreciate it. And I'll vote for the low tech version: use two diodes... -- Eric (...) (28 years ago, 30-Oct-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Automated brick sorter
|
|
Thanks Josh - I rearranged the site shortly after posting it. Glad you liked my efforts. Huw Joshua Delahunty wrote in message <3630DFF7.A7319B21@a...sc.edu>... (...) (28 years ago, 30-Oct-98, to lugnet.robotics)
|