 | | Re: Is there a usable Mac OS X version?
|
|
(...) I think John Hansen actually made a pbForth terminal in NQC. My RCXTcl works on a PC, but I never did get around to packaging it for Macs. Probably because I don't have one myself :-) That being said, once you have a terminal program to talk (...) (19 years ago, 28-Jun-07, to lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx.nqc)
|
| |
| | Is there a usable Mac OS X version?
|
|
Is there a usable version of pbForth for Mac OS X and the USB tower? I have NQC, so there should be no trouble downloading firmware, and Mac OS X has good terminal software, but how do I set up things so that terminal communication goes via the USB (...) (19 years ago, 28-Jun-07, to lugnet.robotics.rcx.pbforth, lugnet.robotics.rcx.nqc)
|
| |
| | RE: Custom firmware crashing on boot
|
|
Here's two things to try since you've only swapped out the VM hich I assume is a replacement for the "c_cmd.c" file. 1. First there is a "#define" that specifies the start address of the file system. If you're 10K larger you're going to need to (...) (19 years ago, 27-Jun-07, to lugnet.robotics.nxt.nxthacking)
|
| |
| | Re: Custom firmware crashing on boot
|
|
(...) It is nice with some action. (...) OK, that is very good. (...) A quick question: Are you running binsert after you compile? It may be worthwhile to look at lines 50-55 in "Makefile". With some effort and a hex file editor you can check if (...) (19 years ago, 28-Jun-07, to lugnet.robotics.nxt.nxthacking)
|
| |
| | Custom firmware crashing on boot
|
|
Hey, I'm new here, so if I seem like a n00b, it's probably because I am. Hopefully my question won't be too annoying. I'm trying to use the NXTGCC 0.0.9 package as a starting point for custom firmware. The main point of my custom firmware is to swap (...) (19 years ago, 27-Jun-07, to lugnet.robotics.nxt.nxthacking)
|
