 | | Re: Brickworld 2007 - Indy 5.00
|
|
(...) Okay, I'm confused. How can an 8' x 10' track be centered on a 4' by 8' surface? What is the actual width of the track? If the whole track fits on a 4' x 8' surface, then I would assume the width must be less then 2'. Gus (17 years ago, 17-Jun-07, to lugnet.events.brickworld, lugnet.robotics)
|
| |
| | Re: Shutdown/Off while program running crashes BrickOS
|
|
(...) Yes, that should be the latest version. (...) That is correct. You shouldn't need to do anything else. At one point, I made some changes to the firmware so the program could also access the run button. But, normally all that is handled in the (...) (17 years ago, 17-Jun-07, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Shutdown/Off while program running crashes BrickOS
|
|
(...) I'm using what appears to be called BrickOS 0.9.0. It was installed using John Hansen's simplified installation from his BricxCC sourceforge site. I was under the impression that on later versions of BrickOS, like what I am using, the firmware (...) (17 years ago, 17-Jun-07, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Shutdown/Off while program running crashes BrickOS
|
|
(...) Gus, It sounds like the code is testing for pressing the run button, but not pressing the power button. I would think testing for shutdown would be good enough, but who knows... :) What version of BrickOS are you using? I'd be glad to take a (...) (17 years ago, 17-Jun-07, to lugnet.robotics.rcx.legos)
|
| |
| | Shutdown/Off while program running crashes BrickOS
|
|
I have a big and somewhat complicated BrickOS program that I believe is reasonably well behaved. All my loops monitor shutdown_requested and I have tested stopping the program with the Run button while the program is in various states and it always (...) (17 years ago, 16-Jun-07, to lugnet.robotics.rcx.legos)
|
