To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *46484 (-5)
  DataogValue and firmware > 0328?
 
Is there such a thing as a firmware greater than 0328 (firm0328.lgo) as supplied with RIS2? There must be because in the NQC manual there is a reference to \"the standard LEGO firmware version 3.30 which is available via the ROBOLAB software\". I do (...) (20 years ago, 10-Apr-07, to lugnet.robotics)
 
  Re: Using NXT Port 4 EIA-485
 
(...) Hi Juergen, Yes, I found this night the entries at Lego-Source-Code... and no line about P-NET-Protocol... My first thought was to implement a simple p-net-node at own MCU, but now I can try my own communication from NXT (master) to external (...) (20 years ago, 10-Apr-07, to lugnet.robotics.nxt, lugnet.robotics.nxt.nxthacking)
 
  Re: Using NXT Port 4 EIA-485
 
Hi Christian, (...) the RS-485 interface is directly connected to the AT91SAM7S USART, so you can choose the bit rate quite freely. (...) No, it is not necessary, P-Net is just a field bus which seems to be popular in Denmark, there are others which (...) (20 years ago, 10-Apr-07, to lugnet.robotics.nxt, lugnet.robotics.nxt.nxthacking)
 
  Re: EggArt - a 4-colour Easter egg painting robot
 
(...) Wonderful. This is not the typical Mindstorms Printer, of course ^_^ Congratulations David! (20 years ago, 10-Apr-07, to lugnet.robotics.nxt)
 
  Re: Using NXT Port 4 EIA-485
 
(...) Hi, halfduplex is not the problem when connecting the NXT to an external MCU. My problem is the bitrate of 921,6 kbits/s. Simple cheap MCU like ATMega didn't support this bitrate (as far as I know). To add an external devices (e.g MCU+SD-Card (...) (20 years ago, 9-Apr-07, to lugnet.robotics.nxt, lugnet.robotics.nxt.nxthacking)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR