 | | Re: thoughts on gbc module reliability
|
|
"Steve Hassenplug" <Steve@TeamHassenplug.org> wrote in message news:35326.66.84.205...air.com... (...) Thread HiJack!!!!!! The new Bionicle sets have some shotting balls in them and they are a little bit bigger than soccer balls (and a little (...) (20 years ago, 29-Jun-06, to lugnet.robotics)
|
| |
 | | Re: thoughts on gbc module reliability
|
|
(...) Ahh the lamentations of the GBC slave...I feel your pain. After beginning my primary GBC module a week after BF'05, I am *still* testing it. It is extremely complicated and and I've had to make countless design decisions and tradeoffs. At one (...) (20 years ago, 29-Jun-06, to lugnet.robotics)
|
| |
 | | Re: thoughts on gbc module reliability
|
|
(...) Rafe, It sounds like all this info jammed up in your brain, before it finally leaked out... :) All these thoughts & calculations are good. As you pointed out, for one module, it's ok if 90% of the balls pass through. However, with ten modules (...) (20 years ago, 29-Jun-06, to lugnet.robotics)
|
| |
 | | thoughts on gbc module reliability
|
|
All GBCers, This will likely be a long post, so be forwarned. It contains some rambling thoughts on development and reliability of GBC modules. Now that I have started writing, I'm not sure exactly where this is headed, but I have this need to try (...) (20 years ago, 29-Jun-06, to lugnet.robotics)
|
| |
 | | Re: Have you got your NXT yet?
|
|
(...) Oh let me tell ya Brian... I have a whole list of non-measurements that just aren't measuring up. (...) I have a feeling my "real" doctor did the exact same thing... there is no bloody way she earned a real degree... she makes Barbie look like (...) (20 years ago, 29-Jun-06, to lugnet.robotics)
|