To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4411 (+5)
  Handy Board newbie looking for ways to expand digital I/O
 
Hi all, I've started playing with the Handy Board last week and needed more digital outputs then provided. After a quick look at the schematics, FAQ's and the manual, I decided to disable the motor circuitry and use the latch mapped to address 0x0e (...) (28 years ago, 27-Sep-98, to lugnet.robotics.handyboard)
 
  My reset blues
 
Hi all, I have problems running my program after downloading it to my HandyBoard. After what Maz Rahm (thank you very much Maz Rahm) replied to Keith (thanks to you too Keith) that in order for the program with the main function in it, to run, I (...) (28 years ago, 27-Sep-98, to lugnet.robotics.handyboard)
 
  Re: Handy Board newbie looking for ways to expand digital I/O
 
Try this: (URL) for up to 3 more 8 bit ports identical to the motor one. Thanks, Joe Hoffmann E-Mail jhoffman@it.sait.ab.ca (...) (28 years ago, 27-Sep-98, to lugnet.robotics.handyboard)
 
  Controlling motor speed/frequency
 
hi all does anyone know if there is a way where we can increase the output frequency of the motor PWM output? i did a test by typing " motor(0,50) " and connecting a probe to Motor 0 +ve and to the L293D gnd pin respectively. the reading on the (...) (28 years ago, 28-Sep-98, to lugnet.robotics.handyboard)
 
  +5v power supply dilemma
 
I have been attempting to run a circuit of my own design which requires both a 9.5-14v DC supply and a 5v DC supply from a 9.6v NiCad. I run the 9.6v straight to the part of the circuit which requires that voltage and that works fine. I then take (...) (28 years ago, 28-Sep-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR