To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *43684 (-5)
  Re: NXT - ARM7's and USB
 
In lugnet.robotics, Kevin L. Clague wrote: Your on the right track but your terminology is a little off. USB like many of the next generation protocols is indeed point-to-point. However, the problem is at the protocol level (as you start to point (...) (21 years ago, 9-Jan-06, to lugnet.robotics, FTX)
 
  Re: mindstorms NXT
 
(...) As we currently understand things, the USB port is a 'slave' port - not a 'master' - so you can plug the NXT into a PC - but you can't plug things like thumb drives into the NXT because that would be plugging a 'slave' USB device into another (...) (21 years ago, 9-Jan-06, to lugnet.robotics)
 
  Re: new Mindstorms servos?
 
(...) I beg to differ. The origninal technic motor was ungeared. It was bad because the first thing it did was try to power unlubed high friction gears. At least with enclosed, lubed close tolerance gears, there's a lot less friction in the gear (...) (21 years ago, 9-Jan-06, to lugnet.robotics)
 
  Re: mindstorms NXT and memory
 
(...) You could - but I might want to store more than one bit of information per square inch (eg a 'confidence' figure or a 'time since last mapped' number - or to store multiple maps so I can see how the map is changing over time). The point is (...) (21 years ago, 9-Jan-06, to lugnet.robotics)
 
  Re: new Mindstorms servos?
 
The problem with gearing down motors in order to exchange RPM for torque is that if you actually NEED RPM rather than torque then you have to gear them back up again. If you have a high RPM motor to start with, you have to gear it down in order to (...) (21 years ago, 9-Jan-06, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR