To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4356 (+5)
  Current Rating use on HB
 
Hi, What is the current rating allow to be use on the HD if currently I am using a stepper motor of rating 4.5V and current 3Amp ? Is it all right directly plug it into the HB? How should I increase the acceptable current rating on the HB? How (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Re: IC dip 120 or Ic dip 210
 
(...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  encoder use in stepper motor
 
hi, How can i use my self build encoder to locate the position when my robot reach a position ? Is it suitable to use a self build encoder together with the stepper motor? The self build encoder consists a photoelectric reflector sensor mounted (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  Fw: Current Rating use on HB
 
(...) that (...) (28 years ago, 8-Sep-98, to lugnet.robotics.handyboard)
 
  bootstrap mode in assembling the HB
 
hi At present I am up to section 4.4, "serial line and stop switch". I have installed all the components as per the section but when testing by applying power and holding down the stop switch, the HB will not go into bootstrap mode. I have not (...) (28 years ago, 9-Sep-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR