 | | LASM Question
|
| Hi, How can I use sensors in Visual Basic using the LASM Command I wan to sense touch on input port 1 Also where can I find complete doc for LASM. Thx SQ (21 years ago, 28-Dec-05, to lugnet.robotics)
| | |  | | Re: train precision
|
| (...) Daniel, One problem you'll run into with most software is that it switches between power and float to adjust the motor levels. It works much better to switch between power and brake. Using most software, the train will continue to speed up, (...) (21 years ago, 27-Dec-05, to lugnet.robotics.rcx.legos)
| | |  | | train precision
|
| A couple of years ago, i used brickOS. Then, i changed to Lejos... I have a moc where i use the RCX to control a train with a lego train motor. It is difficult to control the train with LejOS, because it only has 8 output levels. Two solve the (...) (21 years ago, 27-Dec-05, to lugnet.robotics.rcx.legos)
| | |  | | Re: Lego "style" wire and electrical connectors
|
| (...) Right- I shaved off two of the studs with a paring knife (opposite corners), then the screws just twisted right in. I said 3/4" before, but that's too long. Maybe 1/2-inch? Take a brick with you. I found them at Radio Shack, though, I know (...) (21 years ago, 27-Dec-05, to lugnet.robotics)
| | |  | | Re: Lego "style" wire and electrical connectors
|
| (...) Unfortunately I've triec radio shack for the wire and other parts like LEDs and was worely disappointed. I recently got some reed switches mail-order and am hoping to get at that soon. Not sure how to find a well stocked local electronics (...) (21 years ago, 27-Dec-05, to lugnet.robotics)
| |