 | | Steppr motor pulse problem
|
|
Hi, I've encounter some problem on using the stepper motor with my self-built driver. I am not using the driver in the HB. I have to build out a driver. The driver chip I use is L298 and logic gate chip is L297 or 374( this chip also use in HB) . (...) (28 years ago, 26-Aug-98, to lugnet.robotics.handyboard)
|
| |
 | | Digital Outputs
|
|
I have discovered that I can use PA6 as a digital output and am wondering if the same applies to PA3 if I do not require a piezo buzzer? Thank You Joe Martin joema@mpx.com.au (28 years ago, 26-Aug-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Infrared Detector
|
|
Mekatronics also sell the GPU58 series detectors -----Original Message----- From: Rick Moll <rickmoll@mvp.net> To: Victor Ruiz <ruizvic@mx1.ibm.com> Cc: handyboard@media.mit.edu <handyboard@media.mit.edu>; Rick Moll <rickmoll@mvp.net> Date: Tuesday, (...) (28 years ago, 25-Aug-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: interfacing V2X compass
|
|
(...) I ended up doing the same thing. I appreciate hearing that someone else had thesame problem, and used the same solution. It sure is frustrating that you can't trust the documentation that came with the compass; if you need to reset the thing (...) (28 years ago, 25-Aug-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: interfacing V2X compass
|
|
Rick, I had the same problem. Also the compass would occassionally lock up and require a reset. I tied the reset pin to a digital out and added a routine to take all the necessary pins high and then cycle the reset pin. I reset on initialization and (...) (28 years ago, 25-Aug-98, to lugnet.robotics.handyboard)
|