 | | Re: Pictures of New technique: Cascaded Trinary Pneumatics (aka mid-stop)
|
|
(...) I'll start a schematic next week as this week is an unusual week at work. That should cover the pneumatic circuit. Basically, each stage gets a feed from the compressor, which goes to the middles of the two switches that drive the next stage (...) (21 years ago, 17-Oct-05, to lugnet.technic, lugnet.robotics)
|
| |
 | | Re: error in using brickOS under Bricx Command Center
|
|
(...) Given that your OS Root setting was wrong before and now it is right then modifying that setting did help. It just didn't completely fix your problem. The OS Root setting in BricxCC needs to be set to the Cygwin path to the root of the brickOS (...) (21 years ago, 17-Oct-05, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: High Failure Rate of New Type 9V Geared Motor
|
|
(...) I had the same problem with one of mine. Using them in a fast RC car might do this if it gets slammed into something. I will inform Nathanael Kuipers of the problem since he works at TLC and can tell the proper person. (21 years ago, 17-Oct-05, to lugnet.robotics, lugnet.technic)
|
| |
 | | High Failure Rate of New Type 9V Geared Motor
|
|
Bad tidings! I'm experiencing a rather high failure rate with the new type 9V geared motor (#43362). This motor has been discussed before ((URL) motor can be easily recognised: when you twirl the shaft it turns very little and quickly comes to a (...) (21 years ago, 17-Oct-05, to lugnet.robotics, lugnet.technic)
|
| |
 | | Re: $60 for RCX 1.0 and Serial Tower
|
|
(...) But it's ok in the hands of AFOLs :-) C S Soh (21 years ago, 17-Oct-05, to lugnet.robotics)
|