To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4296 (+5)
  Re: serial library for C++
 
Check out this site. It works well. The only problem I had was timing issues when trying to read and write to the port too quickly. (URL) Message----- From: Mark Wallace <mawalla3@vt.edu> To: Handyboard@media.mit.edu <Handyboard@media.mit.edu> (...) (28 years ago, 12-Aug-98, to lugnet.robotics.handyboard)
 
  Re: Some robot pictures
 
Cool robots, Chuck! I was wondering it when they were created. It looks like the top one was created first and the last is the bottom one. Is that so? ---...--- ericson mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu (...) (28 years ago, 12-Aug-98, to lugnet.robotics.handyboard)
 
  Stepper motors
 
Hello, Does anyone have information on how to run a stepper motor using the Handy Board? Any information you can provide would be appreciated. Mario Garcia (28 years ago, 12-Aug-98, to lugnet.robotics.handyboard)
 
  Re: Some robot pictures
 
Thanks for the Kudos, Actually the timeline is more like "Clyde" (not pictured), "Robotank" (Sherman chassis with a miniboard), "RobotTankII" (Sherman Chassis with 6.270 board), "Comet" (not pictured, R/C conversion w/Miniboard), "Ghost" (not (...) (28 years ago, 12-Aug-98, to lugnet.robotics.handyboard)
 
  Re: Stepper motors
 
Hello mario, Its actually very simple, use an uln2803, connect it to an not used port (i.e. porta in my case), connect the coil wires to the appropriate pins, and the supply lines to the stepper vcc. now you can write values to the port. you should (...) (28 years ago, 13-Aug-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR