Subject:
|
Stepper motors
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 12 Aug 1998 21:31:55 GMT
|
Original-From:
|
Mario Garcia <(mariogar@calpoly.edu)NoMoreSpam()>
|
Viewed:
|
1480 times
|
| |
|
|
Hello,
Does anyone have information on how to run a stepper motor using the
Handy Board? Any information you can provide would be appreciated.
Mario Garcia
|
|
Message has 1 Reply:
 | | Re: Stepper motors
|
| Hello mario, Its actually very simple, use an uln2803, connect it to an not used port (i.e. porta in my case), connect the coil wires to the appropriate pins, and the supply lines to the stepper vcc. now you can write values to the port. you should (...) (26 years ago, 13-Aug-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
