To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4261 (-5)
  Re: General use PCB
 
I too was going to suggest AP having done business with them in the past, however you have to note that they have a 'high density' drilling surcharge. This surcharge is 1 cent for every hole over 24 in 1 sq " of board. Thue "perfboard" (10 x 10 (...) (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)
 
  voltage regulator
 
The voltage regulator on my board (U13) gets so hot that when i touched it it burned my finger. I am using the recomended 12V 500ma ac adaptor. I have been having problems testing the motor circutry and the red motor lights light up when i turn the (...) (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)
 
  Re: General use PCB
 
(...) Option #1: How about making some of your own? If you need 60, then the prices from board houses start getting pretty low. Check out these places: (URL) made up a small spreadsheet for expresspcb and apcircuits pricing, and at quantity 60 you (...) (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)
 
  digital out
 
I am in the need for additional digital outputs. I have read the FAQ and found out that to get 8 more digital outs, I have to connect the 'hc374' clock line to any of the unused output latch selects of the 'hc138'. Has anyone done this? If so, any (...) (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)
 
  Pull Up Resistor
 
Hi, The polaroid documentation mentions that a 4.7K resistor should be placed between ECHO and Vcc. Should this be done when interfacing to the HB? Thanks, Sheridan (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR