To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4251 (+5)
  CW TECHNOLOGY
 
ALL, Do you know if the guy from CW Technology who sells MiniBoard is still doing selling them. I sent him an email, but no reply so far. Thanx. Hachemi (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)
 
  troubleshooting
 
I am assembling my handyboard and am at the stage where i have completed the motor and analog circuits. When I test hte analog circuit the LCD screen prints"press START to test knob..." when i press start the board beeps and the screen goes blank. (...) (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)
 
  yet another hb for sale
 
One Handyboard, from Gleason Research, specifically GRHB-PC, with all cables, power supply, software, LCD, battery, charger board, etc. Get it with two Lego 9 volt gearmotors (they cost me $19 each) and my key for IC 3.2. Used for one small project, (...) (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)
 
  Re: Pull Up Resistor
 
(...) The sensor connectors on the HB already have pullup resistors on the signal inputs (as I recall they were 47K), so you shouldn't need to add an additional pullup. If you want to make sure, just check the signal connection with a voltmeter to (...) (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)
 
  General use PCB
 
We have been using the Radio Shack, Archer board #276-162A. Specifications: Dimensions 3 inches x 4 inches, with copper lands on one side. 30 holes by 25 holes with mounting holes at 2.5 inch and 3.5 inch spacing. We have to told that Radio Shack (...) (28 years ago, 5-Aug-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR