Subject:
|
troubleshooting
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 5 Aug 1998 03:14:31 GMT
|
Original-From:
|
Sam Wurzel <sam_wurzel@loomis.org*Spamcake*>
|
Viewed:
|
469 times
|
| |
| |
I am assembling my handyboard and am at the stage where i have completed the
motor and analog circuits. When I test hte analog circuit the LCD screen
prints"press START to test knob..." when i press start the board beeps and the
screen goes blank. when i testmotors() it downloads to the board but the LCD
screen does not change from the IC message. I checked the potential between pin
51 and 52 and measures 5.00 V The board came equipped with a different knob
than the one in the pictures (it is smaller) The testdigitals() functions
worked flawlessly.
any help would be appreciated
thanks
Sam Wurzel
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|