To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *4211 (+10)
  polaroid ultrasonic detector
 
I'm trying to make the polaroid ultrasonic motion detector compatible with the crickets. Does anyone know where I can find a data sheet for these detectors? I unfortunately broke the last one I was using. I think I must have exceeded either the (...) (28 years ago, 28-Jul-98, to lugnet.robotics.handyboard)
 
  interfacing V2X compass
 
HB Folks, I'm currently using the HB to interface to a Vector 2X compass. I'm using the compass in RAW slave mode, so it's different than the hardware interface that's documented on the HB web site. But I did notice that the documented interface (...) (28 years ago, 28-Jul-98, to lugnet.robotics.handyboard)
 
  Re: What types of IBMs does IC Run on?
 
I would guess this means that IC needs a math co-processor, in other words, a 486 DX or higher. -- Justin Kao <jkao@bigfoot.com> <jkao@flash.net> <ICQ 5903051> (28 years ago, 28-Jul-98, to lugnet.robotics.handyboard)
 
  Re: AC adaptor
 
Hi All, That color code on inductor should read: BROWN(1), BLACK(0), GOLD, SILVER which is (1x10^0)uF => 1uF. Sorry for the confusing and we will mark that in the future. Thanks. Patrick --00---...--- Low cost MIT Handyboard supplier and Official (...) (28 years ago, 28-Jul-98, to lugnet.robotics.handyboard)
 
  Re: Digital In and Analog Out Header
 
It should read: ooo...ooo Signal ---...--- ___...___ 47K RESISTOR NETWORK ___...___ ooo...ooo +5V ---...--- ___...___ ooo...ooo Ground ---...--- Regards, Patrick --00---...--- Low cost MIT Handyboard supplie (28 years ago, 28-Jul-98, to lugnet.robotics.handyboard)
 
  Re: What types of IBMs does IC Run on?
 
i'm pretty sure the DOS version of IC runs on 286's -- it may even run on 8086's that have the 8087 math co-processor. fred In your message you said: (...) (28 years ago, 29-Jul-98, to lugnet.robotics.handyboard)
 
  Re: 68hc11F1
 
Hello mike, (...) I also wanted a small board with MCU, memory, serial and a bus to the outside world. This way i made a general io board and could connect anything to it. (...) You can buy the hc11F1 in 4 speeds, with a freq up to 16 Mhz, setting (...) (28 years ago, 29-Jul-98, to lugnet.robotics.handyboard)
 
  recherche de logiciel C Interactif comme prisenti dans le livre
 
N'ayant pas accés à un micro équipé d'un lecteur de disquette et ne connaissant rien du protocole FTP, je souhaiterais obtenir de votre part la version Gratuite du C Interactif Mes coordonnées : Claise Jerome 23 avenue marcel pagnol 60870 villers st (...) (28 years ago, 29-Jul-98, to lugnet.robotics.handyboard)
 
  Re: recherche de logiciel C Interactif comme prisenti dans le livre
 
please see (URL) your message you said: (...) (28 years ago, 29-Jul-98, to lugnet.robotics.handyboard)
 
  IC floating point bug
 
Has any new information on the IC floating point bug come up? I have been coding neural networks into my robot and was having problems. A simple 'test' network of simple values ran fine, but when I manually entered a real evolved network with many (...) (28 years ago, 29-Jul-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR