 | | Re: Sending Commands to Spybot from RCX - Question from a Beginner to Comm area.
|
| Hi Everybody, I have used SendSpybotMsg and SendSpybotCtrlMessage (of course in connection with resopective set messages) without any problems using BCC 3.3.7.5 and 3.3.7.9. These two commands gives RCX a nice control over spybot. Specially (...) (22 years ago, 8-Feb-05, to lugnet.robotics.spybotics, lugnet.robotics, lugnet.robotics.rcx, lugnet.robotics.rcx.nqc)
| | |  | | Re: Four rotation sensors on a single sensor port
|
| (...) Interesting trick. Thanks for sharing! Philo (22 years ago, 8-Feb-05, to lugnet.robotics)
| | |  | | Four rotation sensors on a single sensor port
|
| Hi, that is possible, they count reliably if you move only one at a time and always stop them when their raw-value is the highest (close to 1023, the axis hole is horizontal/vertical). Have fun Jürgen (22 years ago, 8-Feb-05, to lugnet.robotics)
| | |  | | Re: Internals
|
| Hi Geoffrey, (...) I know that, but the gears that I mean don't take part in the reduction, the reduction is essentially done only by the axis next to the motor. (...) I was only wondering why they would put two gears on an axis when the second one (...) (22 years ago, 8-Feb-05, to lugnet.robotics)
| | |  | | Re: Internals
|
| (...) Indeed, they don't mesh! (...) No, you can't (different tooth size and/or unmatching diameters and/or uncompatible axle and/or different height). (...) Not really easy, but there are plastic clips all around that can be pryed open without too (...) (22 years ago, 8-Feb-05, to lugnet.robotics, lugnet.technic)
| |