To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *40834 (-10)
  Re: POC Exploration Robot
 
Mathieu, My replies are mixed in your message, hope they are helpful. --- Mathieu Lalonde <e0nblue@ssl-mail.com> wrote: [[snip]] (...) This is reasonable, since you are talking about two mindstorms kits, plus vision command, though you could use any (...) (22 years ago, 16-Sep-04, to lugnet.robotics)
 
  POC Exploration Robot
 
<>Hello everyone, I am student in industrial computing (the Quebec counterpart of Computer Science), and I am seriously considering using Lego Mindstorms for my final project. What my teammate and I would like to do is a proof-of-concept exploration (...) (22 years ago, 16-Sep-04, to lugnet.robotics)
 
  Re: RCX 2.0 Power Supply
 
(...) Not nearly impossible. It just requires a little more intelligence be put into the power supply. All the regulated power supplies my company produces contain a circuit called a down programmer. This circuits job is to discharge the filter (...) (22 years ago, 16-Sep-04, to lugnet.robotics, lugnet.trains)
 
  Re: RCX 2.0 Power Supply
 
(...) Thanks for pointing that out, Philo. I think I'll stick to the non-hopped up version! :-) (...) Hopefully you didn't find this out the hard way... Mark (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains, FTX)
 
  Re: RCX 2.0 Power Supply
 
(...) It is nearly impossible to build a power supply that puts out the rated voltage when there is no load. Most will put out too high a voltage (like you have seen), some just shut down. To meassure the voltage of a PS, shorten it with a 1000 Ohm (...) (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)
 
  Re: RCX 2.0 Power Supply
 
(...) Indeed, the input capacitor of the RCX is rated 10V, so I would not do that for a too long time. This 1000µF capacitor, used to keep memory during battery exchange, is directly connected to RCX board supply input. By the way, this capacitor is (...) (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains, FTX)
 
  Re: Lego Compatible (was Re: JCX and Legos...)
 
Joe: I was hoping more people would chime in. Alas, I do not see much interest in this thread right now. Please accept my apologies in advance, my comments below are going to sound like an advertisement ... (...) Such a system already exists and it (...) (22 years ago, 15-Sep-04, to lugnet.robotics)
 
  Re: RCX 2.0 Power Supply
 
(...) You need to check the voltage while the PS is under load. Pretty much every power supply puts out more when the load is low or nothing. Has to do with loads of factors, but mostly quality of the PS (and (thus) internal resistance of the PS) (...) (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)
 
  Re: RCX 2.0 Power Supply
 
(...) On a marginally related note, does someone out there have the equipment to accurately test the output voltage of some typical dc power supplies like the one used for this external ps? I tested every ps I could find in my house (probably 20 or (...) (22 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)
 
  RE: Smart Motor
 
Is this simple enough for you? (URL) Message----- From: PeterBalch [mailto:PeterBalch@c...serve.com] Sent: 15 September 2004 14:58 Cc: [unknown] Subject: RE: Smart Motor (...) years. (...) Yes, I've looked at their circuits. Boy are they (...) (22 years ago, 15-Sep-04, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR