To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *40769 (-5)
  Re: MERLIN valves & sensors
 
(...) I have not looked at the spec sheets, but the web page says 500 mA at 5 volts. The valve will probably draw 900 mA at 9 volts, which is past the current limit of an RCX motor port. Even without the current limit problem, you will have short (...) (22 years ago, 4-Sep-04, to lugnet.robotics)
 
  Re: best way to ignore sensors??
 
(...) This sounds like you have a sensor monitor running continuously, and there is code in the monitor. Perhaps if you set up the sensor monitor to only modify a variable rather than cause the RCX to do things, then your other code could monitor (...) (22 years ago, 3-Sep-04, to lugnet.robotics)
 
  Re: best way to ignore sensors??
 
(...) All right, if you're going to keep reposting your question until somebody answers... ;) Any other programming language will allow you to do that just fine. You write the code that makes the RCX do something in response to sensors; you can (...) (22 years ago, 3-Sep-04, to lugnet.robotics)
 
  best way to ignore sensors??
 
Hi. i am interested in programming my RCX to ignore one sensor port once another has been activated. I haven't found a way to do this with RIS Software so I wa wondering what other programming language would allow me to do this with the least amout (...) (22 years ago, 2-Sep-04, to lugnet.robotics)
 
  DCC for the RCX
 
Snippage If you haven't seen this check it out. DCC for the RCX (URL) (22 years ago, 2-Sep-04, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR