 | | Re: Control Cybermaster from RCX with feedback
|
| (...) This might be old news, but I just tried it anyway... You can connect an RCX motor port to a CyberMaster sensor port and vice versa and get tri-state info. You can distinguish between the motor floating, off, and one of forward or reverse (...) (22 years ago, 11-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
| | |  | | Re: Control Cybermaster from RCX with feedback
|
| (...) Yes, I also hoped for some ready made NQC library e.g., since I saw someone was working on that once (around 2001 in one of these newsgroups) Morten (22 years ago, 11-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
| | |  | | Re: Straight moving with only one rotation sensor
|
| I did this in the past (since disassembled the bot) and found it to be quite reliable; except on slippery surfaces and carpet. :) The trick that I employed was to gear-up the rotation sensor. This causes the rotation sensor to detect even a slight (...) (22 years ago, 11-Jun-04, to lugnet.robotics.rcx.nqc)
| | |  | | P'titgneugneu the stairs climber, was Re: CC3:Stairs,
|
| Here is the (URL) write-up> about the robot I built for CC3:Stairs contest, that happened to win ;o) A bit flimsy, not too pretty, but it did the job! (URL) As the results have not been published here, I inserted the official announcement below. (...) (22 years ago, 10-Jun-04, to lugnet.events, lugnet.robotics, lugnet.technic, lugnet.announce, FTX)
| | |  | | Re: Straight moving with only one rotation sensor
|
| Have you come across the adder/subtractor drive? Although it make the gear chain slightly more complex - it may mean you can leave out the sensor entirely. The drive has two inputs (A and B), and two outputs - one being A+B, and the other A-B. So if (...) (22 years ago, 10-Jun-04, to lugnet.robotics.rcx.nqc)
| |