 | | D/A converter
|
|
"Hi", from Hector Noriega, I am trying to send a data byte from port C out to a D/A converter faster than 1KHZ (target about 10KHZ) . I wrote a test subroutine in assembly code but I can not enable the address decoder using port B for the msb and (...) (28 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | onboard IR receiver
|
|
the problem that i was having with the onboard IR receiver is that the codes that i retrieved from the ir_data() function were inconsistant from the same remote control button. the error was usually manifested in multiples of two, which lead me to (...) (28 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: motor selection
|
|
Where is your source and how do the Cirrus compare to Futuba in price? At a local hobby store in Houston I bought 2 Futuba 3003 (I think) that are the replacements for the 148 which I believe are no longer being made. They cost me about $13 but list (...) (28 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: input impedance
|
|
(...) Hmmmmmm.. as I recall, there are 47k pullups on those inputs. These are used to condition the signals when used as a digital input. The 'HC11 pink book suggests that any input resistance of greater then 10K will "...degrade A/D accuracy." The (...) (28 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Question about Sharp IR demodulators
|
|
I had a similar experience, except that all my IR demodulators were from Radio Shack; two were some I'd gotten in a "grab bag" quite a few years ago, and the others were brand new. The original one reacted to 40KHz the way you describe yours doing - (...) (28 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
|