 | | Re: Include directive, HexMon
|
|
I had same problem, and found that if you put the include files in the same directory as your file to be complied, and then place the file in quotes (eg. #include "6811regs.asm") it will compile. John (...) (28 years ago, 9-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: serial communications
|
|
Justin Here is the file. Please feel free to modify/improve. I'm a doctor not a programmer, and I better keep my day job. Notice it borrows Randy Sargent's and Dr. Richard F. Drushel's routines found in serialio.c and math.c, both on the handy board (...) (28 years ago, 9-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | clock signal needed for decoder chip
|
|
Hello, I am hooking some HP decoder chips to the handyboard. They are HCTL-2020's and they decode a motor position encoder signal. My problem is that I need to hook one of the pins on the 2020 (the CLK pin) to a clock. I'd like to get ahold of the E (...) (28 years ago, 8-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: handshaking
|
|
(...) Regarding your earlier message, if you're just wanting to talk to a GPS, then you don't need handshaking, because I haven't found one yet that supports it. It is a simple three-wire interface to most GPS's, TX/RX and Ground. They don't support (...) (28 years ago, 8-Jun-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: LCD Removal
|
|
All pcodes shipped with IC 3.1/3.2 are designed to work fine either with or without LCD. Prior to 3.1, you have to build a pcode specially to disable the LCD. -- Randy (...) (28 years ago, 8-Jun-98, to lugnet.robotics.handyboard)
|