To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3906 (+5)
  motors
 
That did answer my question. I am not familiar with servo motors, I have only used plain DC motors. I am also familiar with PWM. I was just unable to determine if the same PWM signal that drives plain DC motors could also drive servo motors. From (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)
 
  Re: LCD Removal
 
Hello, Does anyone know if the Rug Warior Pcode run without the LCD? (Pcoderwl.S19) If not : 1 is there another RW pcode that will run without the LCD? I using the RW pcode on my Fingerboard II with out the LCD and I think this may be an issue. (...) (28 years ago, 6-Jun-98, to lugnet.robotics.handyboard)
 
  Re: motors
 
For servo, there is a certain threshold duty cycle (say 50%) of the PWM signal, where anything above this threshold will make it to run forward, and less will make it to run backward. So, you still need to apply the PWM even if the servo is not (...) (28 years ago, 6-Jun-98, to lugnet.robotics.handyboard)
 
  DC motors vs. servo motors
 
The nature of the PWM (pulse width modulation) is entirely different for servo's vs. plain DC motors. For a DC motor, it has a two wire connection. All drive power is supplied over these two wires -- think of a light bulb. When you turn on a DC (...) (28 years ago, 6-Jun-98, to lugnet.robotics.handyboard)
 
  serial communications
 
i have been looking thru the libraries that people have posted on the web, particularly the ones that allow serial communication. i am not sure how the system works, but there are numerous routines which turn handshake on and off, as well as (...) (28 years ago, 6-Jun-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR