To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3896 (-5)
  Radio Shack Tape Measure
 
Can anyone point me to an article on connecting the Radio Shack Tape Measure to the MIT 6.2 controller board. Also, has anyone used this device with either the miniboard or the handyboard. thank you ___...___ ___...___ Jonathan Swaby 305 Sparks Bldg (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)
 
  Re: Infrared Optosensors
 
1/2" is actually pretty good range for a basic reflectance sensor. try using them in the analog inputs -- you should get readings that let you read out to about 1". to get better than that, you need a modulated signal, like Pandit has described. (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)
 
  Re: Infrared Optosensors
 
Hi Brian, I believe you are trying to implement the proximity sensor for object avoidance or collision avoidance, correct ? I believe the QT1114 is designed for the range the you have found. The spec. of the part also indicate the very near range (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)
 
  Problems with Smoot-PWM
 
Hi all, i have problems during download the new smooth-pwm routine into my handyboard. All times my downloader stopped after few seconds with an error message "EOF after 1xxx Bytes ....." I´m using a macintosh (PPC 4400) and use the 6811 download (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)
 
  Infrared Optosensors
 
I interfaced 3 infrared optosensors to the digital inputs on the handyboard. I'm a little dissapointed in their performance however. The only time they give a reading of "true" is if they are about a half an inch or closer from the target. Any (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR