To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *38934 (-5)
  Re: Robolab, byte codes and assembler
 
(...) Don't run it too quickly or too slowly. (URL) Um, that's all I know, besides using BrickOS which has code to make it more accurate. You mentioned that already. Actually, now that I think about it, BrickOS might be able to run assembly language (...) (23 years ago, 26-Nov-03, to lugnet.robotics.rcx.robolab, FTX)
 
  Robolab, byte codes and assembler
 
Having investigated rotations sensors thoroughly, I conclude they have some serious design flaws. Most notably, some samples taken during voltage transitions can be impossible to differentiate from samples at entirely different rotational positions. (...) (23 years ago, 26-Nov-03, to lugnet.robotics.rcx.robolab)
 
  Re: multiple motors
 
(...) So, how well did it work? How did the robot do? (23 years ago, 26-Nov-03, to lugnet.robotics.rcx)
 
  Re: Simulating pneumatic sequencers, was Re: Pneumatic Quadraped 242
 
(...) To do that you have to use the simulator in analog mode, I'm not sure it would work on that kind of circuit (and if it did the simulation would be MUCH slower) Philo (23 years ago, 26-Nov-03, to lugnet.technic, lugnet.robotics)
 
  Re: Simulating pneumatic sequencers, was Re: Pneumatic Quadraped 242
 
(...) Philo, Have you seen this? (URL) amazingly like your SR flop schematics. Kevin (...) (23 years ago, 26-Nov-03, to lugnet.technic, lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR