 | | Datasheet for TI IC
|
|
Hi ! I am searching for the data sheet of a TI speechprocessor TMS3477 (I have the board of a little speech recorder with 90 seconds capacity and max. 16 speech segments with this chip and I will try to connect this board to the Handy Board for a (...) (28 years ago, 28-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Battery types
|
|
...was just wondering if the Handy-Board can run on other types of batteries besides Ni-Cds, such as: NiMH batteries which have higher mAh ratings vs. a Ni-Cd equivalent. Also, will Lithium batteries work with the HB? Are there any performance (...) (28 years ago, 29-May-98, to lugnet.robotics.handyboard)
|
| |
 | | HB with hacked servos as drivemotors
|
|
Hi, I'd like to use two hacked servos _with_ servoelectronic for a Rug Warrior like robot controlled with a HB. Now I am searching for motor driver functions for IC 3.2 to control the servos via the standard motor functions (i.e. fd(), bk(), and so (...) (28 years ago, 29-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Battery types
|
|
I personally use a single 12 V 3Ah Gell cell to power my entire robot. I'm using the 7805 with a heat sink and works just fine. -----Original Message----- From: brian-c@technologist.com <brian-c@technologist.com> To: handyboard@media.mit.edu (...) (28 years ago, 29-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: Battery types
|
|
(...) <SNIP> My understanding is that 7.2V will work fine. I suspect 9.6V is used simply because 8 AA NiCd's fit so well in the specified box. The chief concerns here are: (1) do you have enough voltage overhead for the 7805; and (2) can you draw (...) (28 years ago, 29-May-98, to lugnet.robotics.handyboard)
|