To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *3861 (-5)
  unsubscribe
 
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  Pad sizes and hole sizes
 
I'm working on a board and I would like to avoid much trial and error. I have read much on selection of pad sizes/via sizes and hole sizes but there seems to be some contridiction. Does anyone know what the pad sizes (for ICs), hole sizes (for ICs) (...) (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  unsubscribe
 
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  unsubscribe
 
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
 
  Re: Board not responding
 
(...) The most probable cause of this is a dead 6811. (it spoils rather easily... :(Because everytime i have a problem with the board, it turns out to be nothing more than a shot 6811. Even replacing the 7805 with a LM2931T kills it. (28 years ago, 23-May-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR