 | | Re: Addresses of SPI ports
|
|
Hi Arthur, The SPI expansion header is shown below: ---...--- Pinouts: 1 Gnd | 2 | 1 | 2 Vcc 5V | 4 | 3 | 3 SS* | 6 | 5 | 4 MISO | 8 | 7 | 5 SCK ---...--- 6 MOSI 7 & 8 Not connected I assume you will be using the Handy Board as a MASTER device not a (...) (28 years ago, 20-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: important update to Handy Board standard libraries.
|
|
Will this new lib_hb.c also replace the Smooth PWM lib_hb.c released by Newton Labs? It appears not. What is the easiest way to consolidate the Smooth PWM routines with your improved analog code? Cheers, Skye. +---...---+---...---+ | Skye Legon | (...) (28 years ago, 20-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: important update to Handy Board standard libraries.
|
|
(...) You must manual consolidate the new driver with the smooth-pwm libraries. To consolidate, 1. edit the smooth-pwm lib_hb.c, and remove the function "_raw_analog()", 2. install the new lib_hb.icb file in your IC lib directory (this contains the (...) (28 years ago, 20-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Where can I find spec. of the LM052L
|
|
I have an equivalent LCD screen (sharp L16255), I think, but it is a bit different from the LM052L and I am not sure how to interface it to the handy board. I cannot find any spec. on neither of these LCD screen and just need a hint maybe. Thanks (...) (28 years ago, 22-May-98, to lugnet.robotics.handyboard)
|
| |
 | | setting the best PWM frequency for DC motor
|
|
hello everyone, I found some information on "How do I set best PWM parameters for DC motors?" from the "Robotics Information" homepage, (URL) inside it described that in order to make current to flow steadily in between pulses, you need to satisfy (...) (28 years ago, 23-May-98, to lugnet.robotics.handyboard)
|