 | | RE: How to make a barecode?
|
|
From what I understand of VVL, CodePilot and MicroScouts: The CodePilot has pre-programed "macros" burned into ROM. Each has it's own id-code, so that's why the book can use a one-barcode "program" for each factory standard model behavior. So, I (...) (22 years ago, 6-Oct-03, to lugnet.robotics.codepilot)
|
| |
| | Re: Wheels, Tyres and Tractions
|
|
Hi Jim, (...) Thanks ;o) (...) Definitely YES. That's why as I changed wheels I modified the test vehicule to try to keep attachment point in line with wheel center. It is also important to keep the retaining rope horizontal, to avoid the creation (...) (22 years ago, 6-Oct-03, to lugnet.robotics, FTX)
|
| |
| | RE: Touch sensor problems
|
|
This is good advice. I've had a motor and a couple of 8448 "hydraulics" that have failed and LEGO has cheerfully replaced them. --Russ -----Original Message----- From: Mark H. Near [mailto:markn@SCOCA-K12.ORG] Sent: Sunday, October 05, 2003 4:37 PM (...) (22 years ago, 6-Oct-03, to lugnet.robotics)
|
| |
| | Re: Touch sensor problems
|
|
(...) Hi Giacomo, Looks like that rubber part has lost its conductivity, simple thing you can try is- stick a samll aluminium piece on it annd reassemble it that would work . Nitin Mindsensors Robotics www.mindsensors.com (22 years ago, 5-Oct-03, to lugnet.robotics)
|
| |
| | Re: Touch sensor problems
|
|
(...) Try cleaning it with warm water and a mild detergent and then use some sort of rubber/plastic restorer on it. It's probably shrunk somewhat as it's dried out over the years. If that doesn't work then scavenge a membrane keyboard. -- -- God (...) (22 years ago, 5-Oct-03, to lugnet.robotics)
|
