 | | What is the best way to eliminate mechanical error trough software
|
|
Hi I built a small circular robot base with differential steering using 3" diameter rubber wheels and optical encoders on both wheels. The motors powering the robot are high efficiency German built gear motors using 300 mA when stalled, and rotating (...) (29 years ago, 11-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: What is the best way to eliminate mechanical error trough software
|
|
(...) therefore the robot tends to drift toward the side of the slower motor. (...) one, so I'm looking for some input to help me write an efficient program to keep the robot moving straight. I handled this type of problem by creating a new process (...) (29 years ago, 12-May-98, to lugnet.robotics.handyboard)
|
| |
 | | L293E sense output ??
|
|
Hi, I'm using a L293E to drive my motors. Each driver has a "sense" output and I don't understand the use of it. How can I use those outputs with the Handy-Board ? Thanks for any help, ......... Fred, Cannes, France EMail: fred.maillet@wanadoo.fr (...) (29 years ago, 13-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Interrupt counter rate
|
|
Hi everyone. I use a 4 bits binary counter to measure the no. of pulses emitted from a shaft encoder(TTL output) in order to calulate the speed of a DC motor. But i want to know what is the best frequency that the processor should take the bit (...) (29 years ago, 13-May-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: HandyBoard 10-16 Servo support
|
|
(...) I had exactly the same problem. There is a CMOS chip by Motorola called the MC14028B that is a BCD-to-decimal or Binary-to-octal decoder. All that really matters though is that it will take a 4-bit input and decode up to *10* outputs that are (...) (29 years ago, 13-May-98, to lugnet.robotics.handyboard)
|